Ceilings are Borked

<< < (2/3) > >>

jolrei:
Quote from: morriganrant on 2009 February 06, 22:54:29

Graphics card issue? Do the lower end computers even have this option?


I would think that if you have ANY real graphics card at all, ceilings should work.  I'm running with an on-board ATI X300 (very low-end) and I get fingers, toes, ceilings, shadows, reflections...in short the works.  It may be a memory issue, I suppose.  Does the game start with ceilings visible, but lose them later on?

Latest drivers installed?  I recently had a graphical glitch with AL, which was fixed by new drivers.

BlueSoup:
Maybe drivers? I have an 8800GT and my computer has 3GB of ram and isn't low-end, so I'll try updating drivers and report back.

ETA:  Updating drivers did nothing. :(

Mirelly:
Forgive me for pressing Phyllis' point, but you have not specifically stated that you have tried toggling the ceiling display button. Your reply only indicated that you knew how to place ceilings.

BlueSoup:
Yes, I toggled the ceiling icon.

jolrei:
What happens when you look at the lot in build mode?  Is there a plywood floor above your level, implying that the ceiling exists?  If not, try putting a floor on top of your level.  The ceiling should then exist on the floor below.

/wild-stab-in-the-dark.

Navigation

[0] Message Index

[#] Next page

[*] Previous page